Merge master.kernel.org:/home/rmk/linux-2.6-arm

arch/arm/configs/spitz_defconfig

@@ -897,7 +897,24 @@ CONFIG_UNIX98_PTYS=y
 #
 # I2C support
 #
-# CONFIG_I2C is not set
+CONFIG_I2C=y
+# CONFIG_I2C_CHARDEV is not set
+
+#
+# I2C Algorithms
+#
+# CONFIG_I2C_ALGOBIT is not set
+# CONFIG_I2C_ALGOPCF is not set
+# CONFIG_I2C_ALGOPCA is not set
+
+#
+# I2C Hardware Bus support
+#
+CONFIG_I2C_PXA=y
+# CONFIG_I2C_PXA_SLAVE is not set
+# CONFIG_I2C_PARPORT_LIGHT is not set
+# CONFIG_I2C_STUB is not set
+# CONFIG_I2C_PCA_ISA is not set
 
 #
 # Hardware Monitoring support

arch/arm/mach-ixp4xx/ixdp425-setup.c

@@ -85,7 +85,7 @@ static struct plat_serial8250_port ixdp425_uart_data[] = {
 	{
 		.mapbase	= IXP4XX_UART2_BASE_PHYS,
 		.membase	= (char *)IXP4XX_UART2_BASE_VIRT + REG_OFFSET,
-		.irq		= IRQ_IXP4XX_UART1,
+		.irq		= IRQ_IXP4XX_UART2,
 		.flags		= UPF_BOOT_AUTOCONF | UPF_SKIP_TEST,
 		.iotype		= UPIO_MEM,
 		.regshift	= 2,

arch/arm/mach-pxa/Kconfig

@@ -77,6 +77,8 @@ config MACH_AKITA
 	depends PXA_SHARPSL_27x
 	select PXA_SHARP_Cxx00
 	select MACH_SPITZ
+	select I2C
+	select I2C_PXA
 
 config MACH_SPITZ
 	bool "Enable Sharp Zaurus SL-3000 (Spitz) Support"

arch/arm/mm/flush.c

@@ -155,14 +155,19 @@ static void __flush_dcache_aliases(struct address_space *mapping, struct page *p
  *  space mappings, we can be lazy and remember that we may have dirty
  *  kernel cache lines for later.  Otherwise, we assume we have
  *  aliasing mappings.
+ *
+ * Note that we disable the lazy flush for SMP.
  */
 void flush_dcache_page(struct page *page)
 {
 	struct address_space *mapping = page_mapping(page);
 
+#ifndef CONFIG_SMP
 	if (mapping && !mapping_mapped(mapping))
 		set_bit(PG_dcache_dirty, &page->flags);
-	else {
+	else
+#endif
+	{
 		__flush_dcache_page(mapping, page);
 		if (mapping && cache_is_vivt())
 			__flush_dcache_aliases(mapping, page);